BW Technologies MicroClip XT Manual de usuario descargar pdf (Pagina 11)

GasAlertMicroClip

Safety Information - Read First

aCautions

⇒ Warning: Substitution of components may impair Intrinsic Safety.

⇒ Caution: For safety reasons, this equipment must be operated and serviced by qualified personnel only. Read

and understand the user manual completely before operating or servicing.

⇒ Do not use the detector if it is damaged. Before you use the detector, inspect the case. Look for cracks or

missing parts.

⇒ If the detector is damaged or something is missing, contact

BW Technologies by Honeywell immediately.

⇒ Use only sensor(s) specifically designed for your GasAlertMicroClip model. (See the section,

Replacement Parts

and Accessories).

⇒ Calibrate the detector before first-time use and then on a regular schedule, depending on use and sensor

exposure to poisons and contaminants. BW recommends at least once every 180 days (6 months).

⇒ BW recommends to “bump test” the sensors, before each day’s use, to confirm their ability to respond to gas by

exposing the detector to a gas concentration that exceeds the alarm setpoints. Manually verify that the audible

and visual alarms are activated. Calibrate if the readings are not within the specified limits.

⇒ It is recommended that the combustible sensor be checked with a known concentration of calibration gas after

any known exposure to catalyst contaminants/poisons (sulfur compounds, silicon vapors, halogenated

compounds, etc).

⇒ The combustible sensor is factory calibrated to 50% LEL methane. If monitoring a different combustible gas in

the % LEL range, calibrate the sensor using the appropriate gas.

⇒ Caution: High off-scale readings may indicate an explosive concentration.

⇒ Only the combustible gas detection portion of this instrument has been assessed for performance by CSA

International.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 56 57

Sin comentarios

BW Technologies MicroClip XT Manual de usuario Pagina 11