BW Technologies MicroClip XT Manual de usuario descargar pdf (Pagina 47)

GasAlertMicroClip

Troubleshooting

If you are still unable to correct the problem, contact

BW Technologies by Honeywell.

The detector’s electronics are protected from variations in

humidity and corrosive atmospheres. If you encounter a

problem, try the solutions listed in the following table.

Table 12. Troubleshooting Tips

Problem Possible Cause Solution

The detector does not activate.

→ Depleted battery

→ Damaged or defective detector

→ Charge battery (see

Charging the

Detector)

→ Contact

BW Technologies by

Honeywell

The detector enters alarm mode

immediately when activated.

→ Sensor needs to stabilize

→ Low battery alarm

→ Detector requires calibration

→ Used sensor: wait 60 seconds

New sensor: wait 5 minutes

→ Charge battery (see

Charging the

Detector)

→ Calibrate detector (see

Calibration)

The activation self-test fails.

→ General fault

→ Sensor failure

→ Contact

BW Technologies by

Honeywell

→ Replace sensor (see

Replacing a

Sensor or Sensor Filter)

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 56 57

Sin comentarios

BW Technologies MicroClip XT Manual de usuario Pagina 47