BW Technologies MicroClip XT Manual de usuario descargar pdf (Pagina 34)

GasAlertMicroClip

User Manual

Gas Alarm Setpoints

The detector's gas alarm setpoints trigger the gas alarms

that are described in the table below.

Table 8. Gas Alarm Setpoints

Alarm Condition

Low alarm Toxics and combustibles: Ambient

gas level above low alarm setpoint.

Oxygen: Ambient gas level may be

set to above or below 20.9%

(or 20.8%).

High alarm Toxics and combustibles: Ambient

gas level above high alarm setpoint.

Oxygen: Ambient gas level may be

set to above or below 20.9%

(or 20.8%).

TWA alarm Toxic only: Accumulated value

above the TWA alarm setpoint.

STEL alarm Toxic only: Accumulated value

above the STEL alarm setpoint.

Multi-gas alarm Two or more gas alarm conditions.

Resetting Gas Alarm Setpoints

Note

To change the alarm setpoints, you must connect

the detector to the IR Link adapter and use the

GasAlertMicroClip Soft Tools software. Refer to the

GasAlertMicroClip Soft Tools manual for complete

instructions.

Standard factory alarm setpoints will vary by region.

Occupational Safety and Health Association

(OSHA) standard settings are used as an example.

The following table lists the factory alarm setpoints.

Table 9. Sample Factory Alarm Setpoints

Gas TWA STEL Low High

N/A N/A 19.5% vol. 23.5% vol.

LEL N/A N/A 10% LEL 20% LEL

CO 35 ppm 50 ppm 35 ppm 200 ppm

S 10 ppm 15 ppm 10 ppm 15 ppm

Note

You can disable an alarm by setting the alarm

setpoint to 0.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 56 57

Sin comentarios

BW Technologies MicroClip XT Manual de usuario Pagina 34