BW Technologies MicroClip XT Manual de usuario descargar pdf (Pagina 27)

GasAlertMicroClip

Options

Automatic O

Calibration

TWA Alarm

When the O2 Auto-Calibration on Startup option is

enabled, it forces the detector to automatically calibrate the

oxygen sensor upon activating the detector. The automatic

calibration option is enabled upon shipment.

The TWA Alarm option allows you to select the time-

weighted average (TWA) alarm setpoint for either the H

S or

CO sensor. Refer to

Resetting Gas Alarm Setpoints for the

factory alarm setpoints.

LEL By Vol CH4

STEL Alarm

The LEL By Vol CH4 option is only applicable to the LEL

sensor. If it is enabled, it shows the LEL reading in %vol.

assuming a methane environment.

The STEL Alarm option changes the short-term exposure

limit (STEL) alarm setpoint for either the H

S or CO sensor.

Refer to

Resetting Gas Alarm Setpoints for the factory alarm

setpoints.

STEL Interval

The STEL interval determines the rate at which STEL is

calculated. The detector is shipped with the STEL Interval

set to 15 minutes. This value can be adjusted between 5 and

15 minutes.

Auto Zero on Start-up

When enabled this option (CO/H2S/LEL Auto-Zero on

Startup) allows the detector to auto zero the chosen sensor

during activation. The auto zero option for each sensor is

disabled upon shipment.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 56 57

Sin comentarios

BW Technologies MicroClip XT Manual de usuario Pagina 27