BW Technologies MicroClip XT Especificaciones descargar pdf (Pagina 64)

GasAlertMicroClip XT

Troubleshooting

If a problem occurs, refer to the solutions in the Troubleshooting section. If the problem persists, contact BW Technologies by Honeywell

Table 14. Troubleshooting

Problem Possible Cause Solution

Startup

The detector does not activate. Depleted battery Charge battery. Refer to Charging the Battery

Damaged or defective detector Contact BW Technologies by Honeywell.

The detector enters alarm immediately

when activated.

Sensor needs to stabilize Used sensor: wait 60 seconds

New sensor: wait 5 minutes

Low battery alarm Charge battery. Refer to Charging the Battery

Detector requires calibration Calibrate the detector. Refer to Calibration

Hazardous environment Leave the area immediately. Deactivate and

reactivate in a safe area that is free of hazard-

ous gas, in an atmosphere of 20.9% oxygen.

The activation self-test fails. General fault Contact BW Technologies by Honeywell

Sensor failure Replace the sensor. Refer to Replacing a

Sensor or Sensor Filter.

Detector automatically deactivates

during startup.

Battery power too low to operate Charge battery. Refer to Charging the Battery.

Force Calibration When Overdue option

is enabled and calibration is not attempted

Calibrate the sensor(s) immediately. Refer to

Calibration

Force Bump When Overdue option is

enabled and a bump test is not attempted

Bump test the sensor(s) immediately. Refer to

Bump Test

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 73 74

Sin comentarios

BW Technologies MicroClip XT Especificaciones Pagina 64